Instead of installing an expensive car alarm system or using ineffective methods to prevent your car from getting stolen, learn how to install an inexpensive, hidden kill switch. This kill switch is easy to install and anyone can do it at home with basic tools. It can also work along with your car's current alarm system. How it works is it cuts the power to the fuel pump so you cannot jump start the car, hot wire it, or even push start it. In order to steal the car you need to tow it! It is better than a batter quick disconnect because your computer wont restart and you wont lose your radio stations.
Products Used:
Automatic Wire Strippers:
Crimping Pliers:
On/Off Switch:
Heat Shrink Butt Connectors:
16 Gauge Wire:
Spade Connectors:
Inexpensive Multimeter:
→ Become a ChrisFix Subscriber:
→ Instagram:
→ Facebook:
→ Website:
→ My Channel Home Page:
**If the video was helpful, remember to give it a "thumbs up" and consider subscribing.**
Disclaimer:
Due to factors beyond the control of ChrisFix, I cannot guarantee against improper use or unauthorized modifications of this information. ChrisFix assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. ChrisFix recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of ChrisFix, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not ChrisFix.
0 Comments